Engineering, 21.04.2020 17:46 chony83

Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. The refrigerated compartment of the truck can be considered to the a 9-ft-wide,8-ft-high, and 20-ft-long rectangular box. The refrigeration system of the truck removes heat at arate of 600 Btu/min. The outer surface of the truck is coated with a low-emissivity material, andthus radiation heat transfer is very small. Determine the averagetemperature of the outer surface ofthe refrigeration compartment of the truck. Assume the air flow over the entire outer surface to beturbulent, and the heat transfer coefficient at the front and rear surfaces to be equal to that on sidesurfaces.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. T...

Questions