Engineering, 21.04.2020 23:26 nae467
For a direct shear test on a cohesionless sand, the following are given: - Size of specimen: 75 mm x 75 mm x 30 mm (height) - Normal stress: 200 kPa - Shear stress at failure: 175 kPa Determine a) the angle of friction, and b) the required shear force that cause failure in the specimen if normal stress is 150 kPa
Answers: 3
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
For a direct shear test on a cohesionless sand, the following are given: - Size of specimen: 75 mm x...
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Arts, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00
Mathematics, 27.05.2021 21:00