A. tap wrench
B. extractor.
Engineering, 23.04.2020 19:45 jaymoney0531
12. Dies are turned using a special tool called a/an
A. tap wrench
B. extractor.
C. puller.
D. die stock.
I mark brainliest if you explain:)
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
12. Dies are turned using a special tool called a/an
A. tap wrench
B. extractor.
A. tap wrench
B. extractor.
Questions
Social Studies, 31.01.2020 05:48
Mathematics, 31.01.2020 05:48
Biology, 31.01.2020 05:48
Biology, 31.01.2020 05:48
Mathematics, 31.01.2020 05:48
Biology, 31.01.2020 05:48
Biology, 31.01.2020 05:48
Social Studies, 31.01.2020 05:48
Social Studies, 31.01.2020 05:48
Mathematics, 31.01.2020 05:48
