Engineering, 23.04.2020 19:31 ItsLeyArt

Consider the flow within a round pipe. At the entrance, the flow velocity is uniform at U.. Near the inlet to the pipe, the flow velocity will be a function of of r and z. Downstream of the entrance region, the flow becomes fully-developed and the velocity profile is not a function of 2 and 8. Apply the continuity and the Navier-Stokes equations in cylindrical coordinate (Eq. 9-62, p. 475) to determine the fully-developed velocity profile within the round pipe.

a. List all the assumptions
b. Find all velocity components of the fully-developed flow in the pipe (V, V, V:)
c. Determine the expression for the fully-developed velocity profile in terms of the pres- sure gradient, 3
d. Determine the expression for the fully-developed velocity profile in terms of the max- imum velocity in the fully-developed profile, Umax.
e. Determine the expression for the fully-developed velocity profile in terms of the inlet velocity, U..
f. What is the ratio of Umax to U. for fully-developed pipe flow?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

Consider the flow within a round pipe. At the entrance, the flow velocity is uniform at U.. Near the...

Questions