Engineering, 23.04.2020 21:25 lakhanir2013

A board game has 20 squares in a row. You start at square 1 and end at square 20. You cannot move beyond 20. If your move goes beyond 20, you cannot move and you do nothing during the turn. You spin a wheel where the probability of each move is a follows
Move Percent

1 square toward the finish 10
2 squares towards the finish 10
3 squares towards the finish 10
4 squares towards the finish 10
5 squares towards the finish 10
6 squares towards the finish 10
Nothing 10
Move 1 squares back 10
Move 2 squares back 10
Move 3 squares back 10

Draw the markov chain?
What is the chance the game ends prior to the 11th move?
What is the chance the game ends prior to the 21th move?
What is the chance the game ends prior to the 31th move?
What is the chance the game ends prior to the 41th move?
What is the chance the game ends prior to the 100th move?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

You know the right answer?

A board game has 20 squares in a row. You start at square 1 and end at square 20. You cannot move be...

Questions