Engineering, 24.04.2020 00:16 july00
In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 6000 ft/min, work speed = 40 ft/min, infeed = 0.002 in, and crossfeed = 0.20 in. The number of active grits per square inch of wheel surface = 400. Determine
(a) the average length per chip,
(b) the metal removal rate
(c) the number of chips formed per unit and the average volume per chip?
(d) If the tangential cutting force on the workpiece is 50 lb, what is the specific energy calculated for this job?
Answers: 1
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 60...
English, 07.11.2020 01:00
History, 07.11.2020 01:00
Mathematics, 07.11.2020 01:00
English, 07.11.2020 01:00
History, 07.11.2020 01:00
Mathematics, 07.11.2020 01:00