Engineering, 24.04.2020 00:58 mocheal8216

A paper plant is proposed for a location 1 km upwind from a town. It will emit 40 g/s of hydrogen sulfide, which has an odor threshold of about 0.1 mg/m3. Assume that winds at 10 m above ground are 2.5 m/s, and at the effective stack height they typically vary from 4 – 10 m/s blowing toward the town. If it is summer day with a few broken clouds,

a) What stack height should be used to assure concentrations are no more than 0.1 times the odor threshold at the near edge of town (1 km away)? To be conservative, the stack will be designed assuming no plume rise.

b) Will any buildings (e. g., the country cabin or the doghouse on the far edge of town – hey, dogs matter too!) experience higher concentrations than a residence at the 1 km boundary? Briefly explain your answer.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

A paper plant is proposed for a location 1 km upwind from a town. It will emit 40 g/s of hydrogen su...

Questions