Engineering, 24.04.2020 19:35 Geo777

5. You have been asked to develop a system to mix and bottle orange juice from concentrate. (5 points) Hint: you will need to select a PLC with more than 4 outputs to simulate this system. a. Low level detectors in the water (I1) and concentrate (I2) tanks prevent operating the water (Q1) and concentrate (Q2) pumps. b. The orange juice tank has a high level detector (I4) which stops the pumps in the water and concentrate tanks. c. The conveyor belt motor (Q4) is initiated by a start (I6) and stop (I7) button. d. When a bottle is detected under the spigot (I5), the conveyor belt is stopped e. The orange juice pump (Q3) is operated for 10 seconds to fill the bottle. f. The conveyor belt is then restarted. g. The red indicator light (Q5) is illuminated if the orange juice tank has a low level h. The green indicator light (Q6) is indicated during normal operation.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

5. You have been asked to develop a system to mix and bottle orange juice from concentrate. (5 point...

Questions