Engineering, 24.04.2020 21:31 joeljuarez128oyusun

In both Tung's textbook and course notes, the following approximation was used: "If a new node sends out an attachment to an existing node having k degree with probability Mk, then from the total m attachments sent out by the new node, there will be a fraction mulk of nodes with degree k having a new attachements." This statement turns out to be only approximately true. The reason is that if sending out the m attachements are truely independent, then there will be some probability an existing node receiving two new attachments. This is clearly not allowed; this implies that the m attachements send out by the new node are not really independent. If Nx is the total number of nodes with degree k, what is the exact formula for the fraction of the Nk nodes that have a new attachment? What happens if Nk > m?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.

Answers: 3

Answer

Engineering, 06.07.2019 05:10

Asteam turbine is supplied with steam at 28bar and 425c. a fraction of the steam is extracted at 1.2bar to heat the feed water in one open feed water heater. the rest of the steam expands in the low pressure stage of the turbine to 0.08bar. a)-sketch the regenerative rankine cycle with open feed water heater on the t-s diagram. b)-assuming isentropic expansion in both stages of the turbine, find the cycle efficiency. do not assume negligible pump work.

Answers: 1

Answer

Engineering, 06.07.2019 09:10

Why do side airbags say inflated for several seconds

Answers: 3

Answer

You know the right answer?

In both Tung's textbook and course notes, the following approximation was used: "If a new node sends...

Questions