Calculate pressure at the mid-plane of an annular cylinder of iron powder pressed using double-action press. The punch pressure (i. e., applied pressure) is 100 MPa when the height of the pressed sample is 10 cm. The coefficient of friction is 0.1, radial-to-axial pressure ratio is 0.4, and the wall thickness of the annular compact is 2 cm.

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.