Engineering, 06.05.2020 05:07 JazminFarris1038

In the apparatus, the Dynamic Aqua Crusher, water is injected into a vertical channel at a volume flow rate Q. The diameter of the channel at point 1 is d, and its diameter at point 2 is D. To the right of point 2 is a horizontal channel blocked by a stopper. The small diameter of this horizontal channel is d, and the large diameter is D. To the right of the stopper is a chamber with static water. When the stopper is clamped in place by a screw, the pressure in the chamber is p0. When the clamp is unscrewed, the stopper is free to move. At the right-hand end of the chamber is a ram that can be used to crush things against a wall. Let be the density of water, p1 be the pressure at point 1 in the vertical channel, and H be the vertical distance between points 1 and 2. You may assume that p1 > p0.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

You know the right answer?

In the apparatus, the Dynamic Aqua Crusher, water is injected into a vertical channel at a volume fl...

Questions