Engineering, 06.05.2020 04:10 topangabraith

The flow velocity in a water tunnel is measured with a pitot tube connected to a pre?sure transducer. The dynamic pressure decreased by the pressure transducer is related to the velocity, V, by pd- (pVA2)/2. The electrical output of the pressure transducer, E, was found to be related to the flow velocity by: E-aVA2 +b. To calibrate the measurement system the following measurements were made.

col1 Transducer Output 2.85 3.61 4.415.00 9.24 (volts)
col2 Velocity (m/s) 0.77 1.14 1.38 1.48 2.28 Determine (use 3 significant digits minimum): The constant a and b. using the summations The standard error of the fit. The width of the 95% confidence interval for the voltage, E, in Volts (assume a well- controlled independent variable) The static sensitivity in terms of a and b The correlation coefficient of the fit, r

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

The flow velocity in a water tunnel is measured with a pitot tube connected to a pre?sure transducer...

Questions