Engineering, 05.05.2020 20:09 afloyd642

Electromagnetic waves can carry more data at higher frequencies. Why would a scientist opt to transmit data at a lower frequency instead?

Answers: 3

Show answers

Answers

Transmitting data over low frequency electromagnetic waves can reach great distances before attenuation because are not easily interfered with by obstacles like high frequency waves are. This is because they can diffract over obstacles and pass around them with less shadowing.

A disadvantage of using electromagnetic waves to transmit data is interference. One cause of interference is the transmission ton over same frequency hence the necessity to regulate these waves through policies. Other causes of interference are due to weather or obstacles.

Analogue signal is the decoding of electromagnetic waves into electric pulses (of varying amplitudes) by a decoder and pass the electric circuit in the electronics. However, in digital signal, electromagnetic waves are converted to binary format (0s and 1s). Therefore, analogue signal is a continous signal while digital is discretely broken down into bits.

Digital signal have the advantage of analogue signal over the fact that they can carry loads of information. Analogue signal draws more power than digital signal hence the later is eco-friendly. Digital signals are less likely to be affected by noise unlike analogue signals.

One major application for analogue signals is their use is speakers and microphones. Nonetheless, contemporarily, there are emerging digital microphones and speakers. A popular example of application of digital signal is in the mobile communication industry. The shift from analogue to digital has been greatly revolutionalized communication

Answer from: Quest

d would be the most obvious choice to this question. leaders are supposed to herd their underlings like a shepherd to sheep. a leader should also listen to others when they are talking to one other to gain a better understanding of their mission and surroundings.

explanation:

Answer from: Quest

Mri is one what are your options anyway ?

Another question on Engineering

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Electromagnetic waves can carry more data at higher frequencies. Why would a scientist opt to transm...

Questions