Engineering, 05.05.2020 19:01 bbahena46

In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xylene (density 53.8 lbm/ft^3). One outlet stream of her condenser was measured to have a flow rate of 37 ft^3/min and a concentration of 30/70 n-pentane/p-xylene by volume. The other outlet stream was measured to have a flow rate of 22 ft^3/min and a concentration of 50/50 n-pentane/p-xylene by volume. If the system operates at steady state and the only inlet to her condenser has a flow rate of 59 ft^3/min, what is the inlet concentration of n-pentane in % by volume?Your answer should be between 0 and 100. Round your answer to 1 decimal place for entry into eCampus. Do not enter units. Example: 12.3

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xyle...

Questions