subject
Engineering, 05.05.2020 17:14 guilloryjamira

Air flows through a rectangular section Venturi channel . The width of the channel is 0.06 m; Theheight at the inlet (1) and outlet (4) is 0.04 m. The height (3) in
the Bosphorus is 0.02 m. Compressibility and viscous effects can
be ignored (ρwater = 1000 kg / m3, ρ air = 1.23 kg / m3)
a) Calculate the flow rate if the
water in the small tube connected to the static pressure tap in the throat is drawn as 0.10 m as shown?
b)Calculate the height (h2) in section (2) according to the flow rate you find in part a .
c)Calculate the pressure at the inlet (1) for the fluid to flow ( according to the values you find in a and b )?


Air flows through a rectangular section Venturi channel . The width of the channel is 0.06 m; Thehei

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
You know the right answer?
Air flows through a rectangular section Venturi channel . The width of the channel is 0.06 m; Thehei...
Questions
question
Geography, 03.08.2019 10:20
question
Biology, 03.08.2019 10:20
question
Geography, 03.08.2019 10:20
Questions on the website: 13722367