Engineering, 05.05.2020 08:38 heroxtree

A natural gas-fired Brayton cycle with 푚¤ air, Br = 1.15 kg s−1 . (a) Ambient air at 1.00 bar and 300 K is taken in. (b) A compressor with an inlet-to-outlet pressure ratio of 1:15. (c) Regeneration between the compressor and the combustor, increasing the temperature to 850 K (d) Combustion at constant pressure to 1800 K. (e) A two-stage turbine system with reheat between the stages. Reheat occurs at 6.00 bar and raises the temperature to 1700 K. (f) Discharge to a heat exchanger at 1.40 bar, where waste heat is used to warm steam for the Rankine Cycle. The outlet temperature from this heat exchanger is 900 K. (g) From that heat exchanger, discharge to the regeneration heat exchanger in part 1c. 2. A water-steam Rankine Cycle with 푚¤ water, Ra = 1.60 kg s−1 . (a) A two-stage turbine system, with reheat between the stages. The first turbine inlet is at 560 °C and 160 bar. Reheat occurs at 40.0 bar up to 560 °C. The second-stage turbine outlet is 2.00 bar. (b) Cooling at constant pressure in a condenser via heat exchange with ambient air to saturated liquid. The air used in condenser cooling must not exceed 400 K when it is released from the power plant. (c) A pump from the low-side pressure to the high-side pressure. (d) Heating in a boiler at constant pressure, using the waste heat from the Brayton Cycle in a first stage and natural gas combust

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

A natural gas-fired Brayton cycle with 푚¤ air, Br = 1.15 kg s−1 . (a) Ambient air at 1.00 bar and 30...

Questions