Engineering, 05.05.2020 05:28 olaffm9799
For this problem you will design a controller, C(s), that will satisfy all the following requirements:(a) The closed loop system is stable.(b) The steady state error for a step function input is exactly zero, and the steady state error for a rampfunction input is 0.02.(c) The complex poles have a damping ratio of 0.25, and a natural frequency of 4.(d) Any additional poles are non-dominant. Answer these questions:(a) Show that the controller, C(s)
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
For this problem you will design a controller, C(s), that will satisfy all the following requirement...
Questions
Mathematics, 06.02.2022 16:10
Mathematics, 06.02.2022 16:10
History, 06.02.2022 16:10
Mathematics, 06.02.2022 16:10
English, 06.02.2022 16:10
English, 06.02.2022 16:20
History, 06.02.2022 16:20
