Engineering, 05.05.2020 03:17 Daryn121504

H (z) is the system function for a stable LTI system and is given by:
H (z) =
(1 − 2z−1)(1 − 0.75z−1)/(z−1(1 − 0.5z−1) )
.
(a) H (z) can be represented as a cascade of a minimum-phase system Hmin1(z) and a
unity-gain all-pass system Hap(z), i. e.,
H (z) = Hmin1(z)Hap(z).
Determine a choice for Hmin1(z) and Hap(z) and specify whether or not they are unique
up to a scale factor.
(b) H (z) can be expressed as a cascade of a minimum-phase system Hmin2(z) and a generalized linear-phase FIR system Hlp(z):
H (z) = Hmin2(z)Hlp(z).
Determine a choice for Hmin2(z) and Hlp(z) and specify whether or not these are
unique up to a scale factor.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Asimply supported beam abc of length l has ab of length hl and second moment of area / and bc of length hl and second moment of area i2. determine the strain energy stored in the beam when it is subject to a vertical load f at its midpoint and the consequential central deflection.

Answers: 2

Answer

You know the right answer?

H (z) is the system function for a stable LTI system and is given by:
H (z) =
(1 − 2z−1)...

Questions