Engineering, 05.05.2020 04:38 rutza
The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inlet Air Temperature (C) (Tin and T\infty): 27 Outlet Air Temperature (C): 28Average Inlet Air Velocity (m/s): 10 Heating Element Temperature (C): 550Given: The area of cross section is 0.02286 m2. The diameter and the length of the rod are 0.0125 m and 0.10795 m, respectively. Assume (air): CP = 1007 J/kg-K), Density=1.1614 kg/m3, u=184.6x10-7 (N s/m2 ) Calculate the average h and Nu. Discuss the major error sources.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inle...
Questions
Mathematics, 21.07.2020 14:01
English, 21.07.2020 14:01
Computers and Technology, 21.07.2020 14:01
Mathematics, 21.07.2020 14:01
History, 21.07.2020 14:01
