Engineering, 05.05.2020 21:42 samjohnson2383

A compound die is used to blank and punch a large washer out of 6061ST Al alloy sheet stock 3.2 mm thick. The outside diameter of the washer is 25.0 mm. and the inside diameter is 12.0 mm. Determine the force required to perform the blanking and punching operation under the following conditions: (a) blanking and punching occur simultaneously and (b) the punches are staggered so that punching occurs first, then blanking. The aluminum has a tensile strength of 350 MPa

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

A compound die is used to blank and punch a large washer out of 6061ST Al alloy sheet stock 3.2 mm t...

Questions