Engineering, 06.05.2020 04:45 isabelzavalalopez28
2. A fluid at 14.7 psi (lb-f per square inch) with kinematic viscosity () 1.8 x10-4 ft2/sec and density() 0.076 lb/ft3 enters a 10 inch diameter pipe with a uniform velocity and a Reynolds number 1000. Determine the decrease in pressure going from the entrance to 100 inch downstream the entrance. The entrance length, LLee is given by, LLee = 0.0288DD. DD. (Hint: calculate the pressure drop separately between 1 and 2 and between 2 and 3 because the region 1-2 shows developing flow and region 2-3 shows developed flow) region. The flow becomes fully developed after the entrance length, LLee. The thickness of the boundary layer 1 −� given as (xx) = 5.0xx 2. Show that entrance length for this flow can be expressed LL = 0.01DD. . xxeeDD
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
2. A fluid at 14.7 psi (lb-f per square inch) with kinematic viscosity () 1.8 x10-4 ft2/sec and dens...
Questions
Computers and Technology, 19.11.2019 18:31
Biology, 19.11.2019 18:31
Mathematics, 19.11.2019 18:31
Mathematics, 19.11.2019 18:31
Biology, 19.11.2019 18:31
English, 19.11.2019 18:31
