Engineering, 06.05.2020 05:42 elias1019

An air standard cycle with constant specific heats is executed in a closed pistoncylinder system and is composed of the following four processes: 1-2 Isentropic compression 2-3 Constant volume heat addition 3-4 Isentropic expansion with a volume ratio, r1=V4/V3 4-1 Constant pressure heat rejection with a volume ratio, r2=V4/V1 (a) Sketch the P-v and T-s diagrams for this cycle. (b)Find out T2/T1 as a function of k, r1, r2 only. (c) Find out T4/T1 as a function of k, r1, r2 only. (d)Find out T3/T4 as a function of k, r1, r2 only. (e) Find out T3/T2 as a function of k, r1, r2 only. (f) Obtain an expression for the back work ratio for a fixed minimum-tomaximum temperature ratio T1/T3. The expression should be of a function of T1/T3, k, r1, r2 only. (g)Obtain an expression for the cycle thermal efficiency as a function of k, r1, r2 only.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

You know the right answer?

An air standard cycle with constant specific heats is executed in a closed pistoncylinder system and...

Questions