Engineering, 06.05.2020 05:46 smartperraorwhateva
Design a power transmission speed reducer compound reverted gearbox for a prototype heavy duty lathe machine with the following characteristics:Power to be delivered: 15 HPMotor Speed: 1800 rpmMotor connection to input shaft: timing belt with 2:1 ratio. Headstock with two speeds: 450 and 60 rpm (high and low)Input and output shafts in-lineMaximum gearbox size: 16-in x 16-in base, 24-in heightInput and output shafts extend 4-in outside gearboxConnection to machine body: 4 bolts at the base, centered, 10-in apartParts life: Infinite shaft life, gear and bearing life
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Design a power transmission speed reducer compound reverted gearbox for a prototype heavy duty lathe...
Questions
Mathematics, 22.11.2020 19:50
Mathematics, 22.11.2020 19:50
Biology, 22.11.2020 19:50
Mathematics, 22.11.2020 19:50
Physics, 22.11.2020 19:50
English, 22.11.2020 19:50
Mathematics, 22.11.2020 19:50
Biology, 22.11.2020 19:50
Computers and Technology, 22.11.2020 19:50
Computers and Technology, 22.11.2020 19:50
