Engineering, 07.05.2020 04:02 hanjonez

Question #11 Multiple Choice
Based on the following passage, which of the following is likely true of ironworkers?
Ironworkers have constructed some of the country's most beloved landmarks, from the
Golden Gate Bridge to the St. Louis Arch. Because the work can be dangerous and
requires erens to trust and rely on each other, ironworkers often develop a special
camarader. When a building is "topped out," that is when the final beam is put into
place, ironworkers often celebrate by signing the beam and then hanging a flag or banner
from it
They comprise a relatively new industry.
They are highly independent
They prefer to work on landmarks instead of buildings.
They take special pride in their work

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Question #11 Multiple Choice
Based on the following passage, which of the following is likely...

Questions

SAT, 21.05.2020 21:18

How long ago did most Middle Eastern countries gain their independence? A 10-20 years ago B. 50-100 years ago C. 200-300 years ago