subject
Engineering, 09.05.2020 10:57 hdjehd

Problem 4 (15 points) An incident occurs on a freeway (two lanes in each direction) in a relatively rural area, which reduces the capacity of the freeway to 350 vehicles per hour (one direction). Before the incident, the capacity of the section of the freeway was 3,200 vehicles per hour (one direction). The traffic demand on this section of freeway from the time of the incident until after the traffic backup is cleared is a constant 2,150 vehicles per hour (one direction). It takes 60 minutes to remove the incident and restore the facility to full capacity. Answer the following questions regarding the incident.
(A) How long was traffic affected by the incident (a queue present)?
(B) What was the maximum queue length (in number of vehicles)?
(C) What was the total delay associated with the incident (in vehicle hours)?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Problem 4 (15 points) An incident occurs on a freeway (two lanes in each direction) in a relatively...
Questions
question
Mathematics, 13.10.2020 07:01
question
Chemistry, 13.10.2020 07:01
question
English, 13.10.2020 07:01
question
Mathematics, 13.10.2020 07:01
question
Mathematics, 13.10.2020 07:01
Questions on the website: 13722367