Assuming that the component is made of a brittle steel material and fails under the given operating stresses, failure would occur along planes whose normal is oriented at ~ degrees from the horizontal direction. (Hint: brittle materials are susceptible to failure due to excessive normal stress) A) 6 B) 12 C) 18 D) 24 E) 57 F) 69 13. Assuming that the component is made of a ductile steel material and fails under the given operating stresses, failure would occur along planes whose normal is oriented at ~ degrees from the horizontal direction. (Hint: ductile materials are susceptible to shear failure)

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k