Engineering, 30.05.2020 23:02 Cayden7950
Steam enters and leaves a horizontal 1D pipe steadily at a constant speed with the specific enthalpy to be 4000 kJ/kg and 1500 kJ/kg respectively. Assuming a mass flow rate of 0.5 kg/sec and If there is no significant change in potential energy from inlet to exist, determine the rate of heat transfer between the pipe and its surroundings.
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Steam enters and leaves a horizontal 1D pipe steadily at a constant speed with the specific enthalpy...
Spanish, 08.10.2021 23:30
Mathematics, 08.10.2021 23:30
Mathematics, 08.10.2021 23:30
Computers and Technology, 08.10.2021 23:30
History, 08.10.2021 23:30
English, 08.10.2021 23:30
Mathematics, 08.10.2021 23:30
History, 08.10.2021 23:30
Health, 08.10.2021 23:30
Computers and Technology, 08.10.2021 23:30
Social Studies, 08.10.2021 23:30