Engineering, 31.05.2020 15:57 chickenwing32

The supplement file* that enclosed to this homework consists Time Versus Force data. The first column in the file stands for time (second) and the 2nd stands for force (Volt), respectively. This data were retrieved during an impact event. In this test, an impactor strikes to a sample. A force-ring sensor that attached to the impactor generates voltage during collision. A data acquisition card gathers the generated signals.
• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:
• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:• Take the mass of the impactor as 30 kg and strike velocity as 2.0 m/s.
• Pick the best numerical technique, justify your choice.
• All results must be in SI units.

a) Determine a factor that will be used in the conversion from V to N. The calibration data that supplied by manufacturer as below:
b) Compute the impulse of this event.
c) Obtain acceleration, velocity and displacement histories by using Newton’s second law of motion.
d) Compute the absorbed energy during collision.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

You know the right answer?

The supplement file* that enclosed to this homework consists Time Versus Force data. The first colum...

Questions