subject
Engineering, 04.06.2020 13:58 emmaraeschool

Q2) HTML-Pro is a novel HTML editing application written in Java. The application is supposed to provide the user with adequate functionalities and services to facilitate editing and production of HTML pages. During the requirements elicitation stage, the development team of the HTML-Pro has specified the following functional requirements:

r1. The application shall allow users to create a new empty document.

r2. If the document contains unsaved changes then the application shall allow users to close the document.

r3. The application shall allow users to save the opened document into a file.

r4. The saved document shall store some of sections and HTML tags to reduce the file size.

r5. The application shall allow users to add a new HTML tag and place it in any document section.

r6. When a user creates a new java class, the application shall assign it a unique ID which can be changed.

r7. All team member shall use eclipse in the development process of HTML-Pro.

As a requirement engineer, verify the above requirements, briefly explain where the team has gone right or wrong in their specification and justify your answer.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Q2) HTML-Pro is a novel HTML editing application written in Java. The application is supposed to pro...
Questions
question
Mathematics, 20.04.2021 20:20
Questions on the website: 13722360