subject
Engineering, 05.06.2020 10:58 mine9226

A liquid phase chemical reaction (A → B) takes place in a well-stirred tank. The concentration of compound A in the feed is CA0 (mol/m3 ), and that in the outlet stream is CA (mol/m3 ). Neither concentration varies with time. The volume of the tank contents is V (m3) and the volumetric flow rate of the inlet and outlet streams is Ẇ (m3 /sec). The reaction rate (the rate at which A is consumed by reaction in the tank) is given by the expression r (mol A consumed/s) = kVCA wherek is a constant. (a) Is this process continuous, batch, or semi batch? Is ittransient or steady - state?(b) What would you expect the reactant concentrationCA to equal if k = 0 (no reaction) ? What should itapproach if k [infinity] ( infinitely rapid reaction) ?(c) Write a differential balance on A, starting which terms inthe general balance equation ( accumulation = input + generation -output - consumption) you discarded and why you discarded them. Usethe balance to derive the following relation between the inlet andoutlet reactant concentrations :CA = CA0 / (1 + kV/ ). Verify that this relation predicts the results in part(b).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
A liquid phase chemical reaction (A → B) takes place in a well-stirred tank. The concentration of co...
Questions
question
Mathematics, 09.04.2020 03:01
question
English, 09.04.2020 03:01
Questions on the website: 13722359