Engineering, 06.06.2020 16:57 kaylag8242p2qj2e
A pH sensor is being used to measure real-time changes in pH of a microbial fuel-cell. An A/D converter with 14 bit resolution and a clock of 3.6 MHz is being used to sample and digitize the voltage readings that lie in a range of 0-10V.1. What is the resolution of the voltage signal? 2. What is the maximum error in Volts? 3. How many bits are needed to achieve a maximum error that is less than 0.2 mV? 4. What is the percent maximum error for V in the range (5 - 10](v)? 5. Find the maximum conversion time if the A/D was a successive approximation register (SAR).6. Suppose that the measurement is corrupted by 3-bit white noise, uniformly distributed. What is the variance of the noise in V and what would be the variance if we perform averaging of N values, where N = 2, 5, 107.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
You know the right answer?
A pH sensor is being used to measure real-time changes in pH of a microbial fuel-cell. An A/D conver...
Questions
Advanced Placement (AP), 22.05.2020 04:06
Mathematics, 22.05.2020 04:06
Mathematics, 22.05.2020 04:06
Mathematics, 22.05.2020 04:06
