Engineering, 07.06.2020 05:00 underfellrocks

You company is in the business of making computer monitors. Through a market survey, the company has identified a demand for a new computer monitor product and has also determined that the market would bear a unit price of $207. To manufacture this new product, however, the company will need to invest in a new production assembly line. You are asked by your boss to consider two options of production assembly lines. • Option #1: A labor-intensive process which has a fixed cost of $348,000 and a variable cost of $153 per monitor.
• Option #2: A highly automated process (capital intensive) that has a fixed costs of $1,264,000 and a variable cost of $94.5 per monitor.
Your job is to figure out how many computer monitors the company has to produce (and sell) to justify the high cost of initial investment for Option #1.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

You know the right answer?

You company is in the business of making computer monitors. Through a market survey, the company has...

Questions