Consider the following code:
int Num1 = 5.2;
int Num2 = 3;
int Result;
void setu...
Engineering, 08.06.2020 10:57 ILOVEAARON39821
Consider the following code:
int Num1 = 5.2;
int Num2 = 3;
int Result;
void setup() {
// put your setup code here to run once:
Serial. begin(9600);
Result = Num1 * Num2;
}
void loop() {
// put your main code here to run repeatedly:
}
What is the result value after executing the code? Is it correct? Justify your answer.
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 19:20
Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.
Answers: 3
Engineering, 04.07.2019 19:20
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
English, 28.09.2020 07:01
Mathematics, 28.09.2020 07:01
Physics, 28.09.2020 07:01
Mathematics, 28.09.2020 07:01
Biology, 28.09.2020 07:01
Mathematics, 28.09.2020 07:01
English, 28.09.2020 07:01
History, 28.09.2020 07:01