Engineering, 13.06.2020 15:57 paytonpaige22

Using Circuit 5.1, answer the following questions. Calculate the voltage across the capacitor, assuming that the circuit has been left for a significant amount of time after the power supplies are connected to the other components (this is the initial voltage, vc(0- )). 2. At t = 0, the 10V source is turned off (V=0). Determine how the voltage across the capacitor changes as a function of time. That is, determine an equation for vc (t). a. Find vc(0+) b. Find vc([infinity]) c. Find  d. Write an equation for vc (t) e. Calculate the voltage for the following times: t = , t = 2, t = 3, t = 4, t = 5, t = 6, t = 10,

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

Answer

You know the right answer?

Using Circuit 5.1, answer the following questions. Calculate the voltage across the capacitor, assum...

Questions