Engineering, 15.06.2020 13:57 cearp
A plate-loading test using a plate of 305mm diameter was performed on the
surface of the sub-grade. A total lead of 40kw was applied & a deflection of
2.54mmm was measured. Assuming that the sub-grade has a poison’s ration
of 0.3, determine the elastic modulus of the sub grade.
Answers: 1
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
A plate-loading test using a plate of 305mm diameter was performed on the
surface of the sub-grade....
Biology, 28.06.2019 11:00
Mathematics, 28.06.2019 11:00
Business, 28.06.2019 11:00
Chemistry, 28.06.2019 11:00
History, 28.06.2019 11:00
Arts, 28.06.2019 11:00
Biology, 28.06.2019 11:00
History, 28.06.2019 11:00
History, 28.06.2019 11:00