Engineering, 15.06.2020 21:57 kev71

[Q3] A small-scale open cycle thermal power plant consists of a feed water supply system that includes a steam generator, a hydraulic feed pump and an electric motor as shown in the
figure below. Water from a nearby natural reserve is required to be supplied to the
steam generator using a feed pump which is driven by an electric motor of 20,000 Watts
capacity and 89% efficiency. The rate of flow of water through the pump is 60 kg/s and
the diameters of the suction and the exhaust pipes of the pump are same. Determine:
a) The mechanical work delivered by the motor to the hydraulic pump.
b) The mechanical power gained by water in the hydraulic pump.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

You know the right answer?

[Q3] A small-scale open cycle thermal power plant consists of a feed water supply system that inclu...

Questions