Engineering, 16.06.2020 23:57 aallyssabrown0120

Seventy-five liters of liquid ethanol at 70.0C and 55 L of liquid water at 20.0C are to be mixed in a well-insulated flask. The energy balance for this constant pressure process is Q =change in H. (a) Neglecting evaporation and the heat of mixing, estimate the final mixture temperature.(Aspart
of the calculation, use data in Table B.2 to estimate a linear formula for the heat capacity of liquid ethanol.)
(b) If the experiment were actually performed and the final mixture temperature were measured, it would almost certainly not equal the value estimated in part (a). List as many reasons as you can think of. (There are at least seven of them, most involving approximations made in the estimation.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 05.07.2019 23:20

Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Air (c-1.006 kj/kg.k, r-0.287 kj/kg.k) enters a nozzle steadily at 280 kpa and 77°c with a velocity of 50 m/s and exits at 85 kpa and 320 m/s. the heat losses from the nozzle to the surrounding medium at 20°c are estimated to be 3.2 kj/kg. determine (a) the exit temperature and (b) the total entropy change for this process. solve this problem using constant specific heats.

Answers: 1

Answer

You know the right answer?

Seventy-five liters of liquid ethanol at 70.0C and 55 L of liquid water at 20.0C are to be mixed in...

Questions