Engineering, 19.06.2020 18:57 rayniqueamee2002

Refrigerant-134a at 700 kPa, 70°C, and 7.2 kg/min is cooled by water in a condenser until it exists as a saturated liquid at the same pressure. The cooling water enters the condenser at 300 kPa and 15°C and leaves at 25°C at the same pressure. Determine the mass flow rate of the cooling water required to cool the refrigerant. The enthalpies of R-134a at the inlet and exit states are 308.34 kJ/kg and 88.82 kJ/kg. The enthalpies of compressed water at both states are 62.98 kJ/kg and 104.83 kJ/kg.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

Refrigerant-134a at 700 kPa, 70°C, and 7.2 kg/min is cooled by water in a condenser until it exists...