Engineering, 20.06.2020 02:57 leahandmaryssa

Since the thermal conductivity of still air [0.025 W/(moC)] is much smaller than the thermal conductivity of glass [0.80 W/(moC)], the temperature difference across the double pane window is almost entirely over the air gap. (Again, in this steady state, the rate of heat flow through the glass and air are the same for the double pane window, so if the conductivity of air is much smaller than that of glass, the temperature difference across the air must be much larger than that across the glass for these windows.) Considering this, what is the ratio of the rate of heat flow through a cheap window with a single pane of glass 5-mm thick compared to a nicer double pane window with an air gap of 5 mm if the temperature difference across them is the same (and they have the same areas)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Since the thermal conductivity of still air [0.025 W/(moC)] is much smaller than the thermal conduct...

Questions