A) mi(t) = sin(2007)
b) m2(t) = sinc(100nt)
c) m3(t) = e-||
d) m4(t) = I14.05)
e...
Engineering, 21.06.2020 03:57 ncosmebaez15
A) mi(t) = sin(2007)
b) m2(t) = sinc(100nt)
c) m3(t) = e-||
d) m4(t) = I14.05)
e) m5(t) = A(-0.5)
You will perform demodulation of Only ONE message signal among the five described above, which will depend on the last digit of your student ID. Your message signal is determined as mk(t) where k = ( [the last digit of your student ID] mod 5 + 1).
Your demodulator consists of multiplier of carrier signal followed by a low pass filter (LPF). Implement MATLAB codes to realize this demodulation processing; and from this processing, plot the spectrum of the demodulated signal. Compare this with the original spectrum of the message.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Questions
Geography, 24.10.2019 23:43
Computers and Technology, 24.10.2019 23:43
Mathematics, 24.10.2019 23:43
Mathematics, 24.10.2019 23:43
