Engineering, 21.06.2020 11:57 ld966057

An aluminium bar 600mm long, with diameter 40mm, has a hole drilled in the center of the bar. The hole is 30mm in diameter and is 100mm long. If the modulus of elasticity for the aluminium is 85GN/m2, calculate the total contraction on the bar due to a compressive load of 180kN.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

An aluminium bar 600mm long, with diameter 40mm, has a hole drilled in the center of the bar. The ho...

Questions