Engineering, 27.06.2020 02:01 DaFuzzyDude
The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0"+/-0.1"). If a jig is to be used to locate hole B by inserting a locator pin in hole A of ø(3.85"+/-0.05"), due to the slack between the jig locator pin and hole A: a. What are the potential limits in the location of hole B? b. Are these potential limits acceptable? c. If the potential limits are not acceptable, how would you make them acceptable? In part c, a bushing will be used to make hole B. What should be the specification for bushing location tolerance?
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
You know the right answer?
The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0...
Questions
English, 01.04.2020 01:52
Health, 01.04.2020 01:52
Mathematics, 01.04.2020 01:52
Mathematics, 01.04.2020 01:52
Mathematics, 01.04.2020 01:52
History, 01.04.2020 01:52
Advanced Placement (AP), 01.04.2020 01:52
English, 01.04.2020 01:52
Mathematics, 01.04.2020 01:52
Mathematics, 01.04.2020 01:52
