Engineering, 03.07.2020 04:01 KIAZTUNEZ

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected to load taking a constant current of 35A. (a) Draw the waveform of output
voltage. (b) Calculate average value of load voltage for a firing angle of 20°
(c) average load power,
(30 mark)
Q2. Explain with necessary equation and drawing the principle operation of the boost
chopper
(35 mark)
Q3. A square wave output single phase bridge inverter supplies an 80 resistor with 40mH
inductance load. Load fundamental rms voltage is 135V at 60Hz. Calculate:
(a) voltage of the dc supply.
(b) rms value of load voltage, load current and third harmonic voltage.
(c) Load power
(35 mark)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected...

Questions