subject
Engineering, 15.07.2020 01:01 heysorryguys

Draw the and translate
chart beginn
The room
The following data apply to an A/C unit. Room sensible heat and latent heat are
11.6kW and 11.6 kW respectively, inside condition is 25°C DBT, 50% RH. Outside
design condition is 35 °C DBT and 27.8 °C, return air from the room is mixed with
outside air in the ratio of 4:1 before entering the cooler coil. Return air from the room
is mixed with the air leaving the coil in the ratio of 1:4. cooling coil bypass factor 0.1,
the air may reheated if necessary before supply to the room. Coil temperature is 10
°C. find a-supply air condition b- refrigeration load due to reheat c- total refrigeration
load capacity d- the quantity of fresh air supplied.
RSH. There
M2. sincet
we should
till this lir
intersectior
supply con
S
O MTW Mall
25°C, 50%
Qs=11.6
QI=11.6
R
R
R

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
You know the right answer?
Draw the and translate
chart beginn
The room
The following data apply to an A/C unit...
Questions
Questions on the website: 13722362