Engineering, 15.07.2020 01:01 Jasten

1. What is the Hardness (HB) of each of the alloys?a) 0.25 wt%C with spheroiditeb) 0.25 wt%C with coarse pearlitec) 0.60 wt%C with fine pearlited) 0.60 wt%C with coarse pearlite. The tolerance to all answers is +/- 10 %.1. 1152. 1353. 2204. 1852. Based on the hardness values determined in Part 1, what is the tensile strength (in MPa) for each of the alloys? a) 0.25 wt%C with spheroiditeb) 0.25 wt%C with coarse pearlitec) 0.60 wt%C with fine pearlited) 0.60 wt%C with coarse pearlite. The tolerance to all answers is +/- 10 %.1) 1162) 1383) 2314) 191

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

You know the right answer?

1. What is the Hardness (HB) of each of the alloys?a) 0.25 wt%C with spheroiditeb) 0.25 wt%C with co...

Questions