Engineering, 21.07.2020 17:01 brennarfa

A long, cylindrical, electrical heating element of diameter D 10 mm, thermal conductivity k = 240 W/mK, density rho = 2700 kg/m3, and specific heat Cp-900 J/kg-K is installed in a duct for which air moves in cross flow over the heater at a temperature and velocity of 27°C and 12 m/s, respectively. The electrical energy is being dissipated at a rate of 537 W/m Evaluate air properties at 450 K. Solve for the following:
a) Reynolds number
b) Nusselt number
c) steady state temp, in K
d) Biot number
e) How long does it take for the element to come within 10°C of the steady state temperature, in s?
f) Knowing the steady state temperature, what is the actual value of the film temperature that should be used to find the air properties, in K? (Hint: Do not redo the problem.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

A long, cylindrical, electrical heating element of diameter D 10 mm, thermal conductivity k = 240 W/...

Questions