top-down design
Engineering, 28.07.2020 07:01 melo2424
Which type of engineering design uses an already-existing design?
A.
top-down design
B.
spiral design
C.
bottom-up design
D.
incremental design
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Which type of engineering design uses an already-existing design?
A.
top-down design
top-down design
Questions
Health, 29.09.2019 14:30
History, 29.09.2019 14:30
History, 29.09.2019 14:30
Mathematics, 29.09.2019 14:30
History, 29.09.2019 14:30
Spanish, 29.09.2019 14:30
Mathematics, 29.09.2019 14:30
