subject
Engineering, 28.07.2020 20:01 arivalen

Determine if each of the following statements is true or false 1 Larger atoms are better nucleophiles due to polarizability.
2 The identity of the nucleophile affects the rate of an SN1 reaction.
3 SN2 reactions proceed via frontside attack.
4 Bimolecular reactions tend to be stereoselective.
5 SN2 reactions invert all stereocenters in a haloalkane.
6 Cl-, OH-, and H- are good all leaving groups.
7 Good bases tend to be good nucleophiles
8 Branching adjacent to a reacting carbon slows SN2 reactions due to steric hindrance.
9 SN1 reactions are slowed by hyperconjugation of the carbocation intermediate.
10 The rate determining step for SN1 reactions is the same as the rate determining step for E1 reactions.
11 It is possible to get E1 alone but SN1 is always accompanied by E1.
12 Leaving group ability depends only on pKa of the conjugate acid.
13 Good nuclephiles are also good leaving groups.
14 Protic solvents solvate large ions better than small ions because of increased surface area.
15 Steric hindrance is a major factor in determining between SN2 and E2 mechanisms.
16 Backside attack always converts R to S and vice versa.
17 Nucleophile ability is solely dependent on the pka of the conjugate acid.
18 A high concentration of good nucleophile will increase the ratio of SN1 product to E1 product

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
You know the right answer?
Determine if each of the following statements is true or false 1 Larger atoms are better nucleophil...
Questions
question
Mathematics, 29.01.2020 04:09
Questions on the website: 13722361