Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
¿La ingeniería puede y debe ser uniforme?...
Questions
Mathematics, 17.05.2021 18:00
Geography, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Social Studies, 17.05.2021 18:00
English, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
Mathematics, 17.05.2021 18:00
