Engineering, 29.07.2020 05:01 sehaamxoxo34
Describe the meaning of the different symbols and abbreviations found on the drawings/documents that they use (such as BS8888, surface finish to be achieved, linear and geometric tolerances, electronic components, weld symbols and profiles, pressure and flow characteristics, torque values, imperial and metric systems of measurement, tolerancing and fixed reference points)
Answers: 1
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Describe the meaning of the different symbols and abbreviations found on the drawings/documents that...
French, 05.07.2019 07:30
Social Studies, 05.07.2019 07:30
Mathematics, 05.07.2019 07:30
Chemistry, 05.07.2019 07:30
History, 05.07.2019 07:30
Advanced Placement (AP), 05.07.2019 07:30
Mathematics, 05.07.2019 07:30
Mathematics, 05.07.2019 07:30
Mathematics, 05.07.2019 07:30
Biology, 05.07.2019 07:30